278x137x1887611.jpg.pagespeed
Clemens Fuel Systems company logo

We keep the cost of compliance testing down!                                    

HOURS

Call Today 850-265-8881

Containment Sump Citations

Our inspectors have a thorough knowledge of the policies and understand exactly what to look for when inspecting your sump containment devices. Feel confident with our abilities to handle it for you!

Call for 48 hour emergency response times when you need it most!

 

Containment Sumps and Inspection

All regulated UST systems installed after January 11, 2008 are required to have containment sumps installed at the tank-top and under product dispensers. Certain piping arrangements may also require the use of transition sumps as well. Containment sumps on new UST systems and those used for release detection on existing UST systems are required to be tested every 36 months. Containment sumps used for pressurized piping release detection where there is no line leak detector or containment sumps used as a spill containment device around a fill pipe or pump-out point are required to be annually tested. Some sites may have containment sump testing requirements not listed here due to unusual configurations, variances, or specific requirements in the installation pproval letter. General requirements for containment sump installation and testing are found in the UST Regulations in the sections shown in the table below:

 

 

With over 20 years of experience, you can trust us to handle your sump inspections with authority and expertise.

Clemens Fuel Systems, Inc. company address Line Testing Clemens Fuel Systems

Containment Sump Citations

Part B

Part C

Part D

Installation

Installation

Installation

Testing

Testing

Testing

New

New

New

New

New or

Existing

Existing

Existing

Existing

Existing

1.4.

2.4.

1.25.

2.26.

1.4.

2.4.

1.25.

2.26.

1.4.

2.4.

SumpPump2-CLR-scr